![]() ![]() For information about the ESXi Dump Collector, see vCenter Server Installation and Setup and vSphere Networking. Provides full integration with VMware Site Recovery Manager without the need for additional scripts. Choose the backup repository and tick the Configure secondary destination for this job checkbox: Now you need to configure the secondary target by selecting Nimble Snapshot and Nimble Collection Replication. In this example, all initiator ports and the target portal are configured in the same subnet. If your target has only one network portal, you can create multiple paths to the target by adding multiple VMkernel ports on your ESXi host and binding them to the iSCSI initiator. Create a new backup job and add the required VM (s). Multiple paths for an iSCSI target with a single network portal. To collect your host's diagnostic information, use the vSphere ESXi Dump Collector on a remote server. The RDM method offers the following benefits: Provides a means for guest VMs to control the entire volume when connected to HPE Nimble Storage FC arrays. After that, Veeam Backup & Replication will back up the VM from the secondary storage. If you boot from SAN using iBFT, you cannot set up a diagnostic partition on a SAN LUN.If a separate LUN is used for the diagnostic partition, multiple hosts can share the LUN. If you configure the diagnostic partition in the boot LUN, this LUN cannot be shared across multiple hosts. ![]() When the host starts, it boots from the LUN on the SAN rather than from its local disk.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |